IPS 5.0K TWO CHANNELS PROFESSIONAL POWER AMPLIFIER
IPS 5.0K
TWO CHANNELS PROFESSIONAL POWER AMPLIFIER
- 2 x 2600 W Class-H power
- Fast response and low distortion
- Stereo, parallel, bridge modes
- Extensive protection circuit














Features
- 2 x 2600 W Class-H power
- Fast response and low distortion
- Stereo, parallel, bridge modes
- Extensive protection circuit
- Variable speed cooling system
- Signal, clip, fault led indicators
- XLR input connectors
- SpeakON and binding post output connectors
- Limiter on each channel
IPS Series is a range of two channel professional amplifiers that combine the latest high-performing class-H power amplification technology with long-term reliability. IPS 5.0K is a 2-channel power amplifier that delivers up to 2 x 2600 Watts at 4 Ohms impedance. It features independent gain control, signal/clip and fault indicators, stereo XLR input and output link, stereo/parallel/bridge switch, speakON, and binding post output connectors. Moreover, it is protected against short circuits. Thanks to its high-efficiency heat sinks and variable speed fans, IPS 5.0K can withstand extreme heat conditions, ensuring complete reliability.
Read MorePart number:
12100061
IPS 5.0K
220-240V, EAN 8024530019631
12100062
IPS 5.0K
120V, EAN 8024530019648
Energize your Sound
IPS are high-performance, versatile 2U power amplifiers for install applications, using sophisticated Class-H topology for two single-channel outputs, two parallel outputs, or a single-channel bridge operativity. High quality, low distortion audio output, flawless reliability and safety, industry-standard speakON connectors, and binding post terminals make IPS Series electronics the workhorse solution for mobile sound systems and permanent installation applications.

The Advantage of Class H
Remarkable Audio Performance

Channel B output to loudspeakers (SPEAKON and BINDING POST connectors). Do not use this output if the amplifier is set to BRIDGE mode. See both ‘Operation modes’ and ‘SPEAKON connector wiring’ manual sections.
2 CH A OUTPUT
Channel A output to loudspeakers (SPEAKON and BINDING POST connectors). If the amplifier is set to BRIDGE mode, only connect this output. See both ‘Operation modes’ and ‘SPEAKON connector wiring’ manual sections.
3 CH A INPUT
Channel A balanced audio input (female XLR connector).
4 CH A LINK
Channel A balanced parallel audio output (male XLR connector). This output is linked in parallel with the channel A input and is useful to link another amplifier.
5 SENSITIVITY switch
Set the sensitivity switch to either 0.775 V or 1.4 V, which is input signal voltage required to get the maximum power output from the amplifier.
Channel B balanced audio input (female XLR connector).
7 CH B LINK
Channel B balanced parallel audio output (male XLR connector). This output is linked in parallel with the channel B input and is useful to link another amplifier.
8 MODE switch
Before turning the amplifier on, set the amplifier mode selector to the right position among BRIDGE, PARALLEL (mono) and STEREO. See the ‘Operation modes’ manual section.
9 RESET button
Push this button to reset the amplifier when is muted due to the thermal protection.

Self-protecting Architecture
Specifications
2 x 1500 W @ 8 ohm
1 x 5200 W @ 8 ohm (bridge)
Related products
Downloads
RCF products are continually improved. All specifications are therefore subject to change without notice.
Create your User Area.
